-
Recent Posts
- Don’t overorder Roadster Factory Wiring Clip Sleeves for a Triumph TR3A
- Balancing, installing the Cooling Fan Assembly on a Triumph TR3A
- Replacing Front Oil Seal/Installing Speedi-Sleeve/Timing Chain/Motor Mounts on a Triumph TR3A
- Rebuilding a Girling Master Cylinder Reservoir on a Triumph TR3A
- Installing Cubby/Glove Box in a Triumph TR3A
Archives
Categories
Meta
Monthly Archives: March 2013
Identifying bolts, nuts, other loose parts
I have a bunch of bolts in coffee cans, etc. from the previous owner. As I attempt to reassemble the TR3, I am struggling to be sure as to which bolts belong where. The part number can be matched to … Continue reading
Posted in Uncategorized
Leave a comment
Priming the oil after sitting awhile
From http://www.british-cars.net/triumph-tr6-bbs/ign-lite-and-oil-priming-200302020326004648.htm Instructions for a TR6… Remove the Distributor and the the dist drive gear. Get a 1/2″ wooden dowel(6″-8″long), and cut a slot in one end. the slot should be not quite 1/8″ wide, and about 1/4″ deep. this … Continue reading
Posted in Uncategorized
Leave a comment